Global Statclean Systems
Global Statclean Systems
GT Karnal Road, Swaroop Nagar, New Delhi, Delhi
GST No. 07ASDPG4151H1Z1
Send E-mail
Call 0804802328591% Response Rate
Home  » Our Products » 

New Items

Get Best Quote

Approx. Rs 15 / Piece Get Latest Price

Product Details:
Usage/ApplicationAnti Dust Pollution
Weight20 g

Daily exposure to air pollution is dangerous. Get our face mask Shield to Shield Your Lungs. Step out for work daily with the pollution mask

Yes! I am interested

Get Best Quote

Approx. Rs 1,950 / Kg Get Latest Price

Product Details:
Minimum Order Quantity2 Kg
Material CompositionSN63Pb37

63/37 T3 Solder Paste NCS 63 solder paste is a state of the art made by using high thixotropic no-clean flux and oxide-free spherical powder. This paste is formulated to minimize the soldering defects and long term reliability with defect-free performance No clean flux residues are non-tacky and non-corrosive which gives long terms electrical reliability hence no post solder cleaning is required No change in viscosity after continuous printing thus gives stable printing on high-density electronic assemblies. No bridging, No solder ball, and No slumping after continuous printing Shiny and smooth solder joints STATE Alloy composition --> Sn63 Pb37 Melting point--> 183 º C Particle size--> 20~38μm ( T 4) & 25~ 45 μm ( T 3 ) Powder shape --> Spherical Flux content --> 10 ± 0.50 wt Viscosity --> 180 to 200 Pa.S Shelf life : 6 months Storage conditions : Below 10ºC Instruction For Using a. SOFTENING BEFORE USING:- Take out the solder paste from the refrigerator and keep it at room temperature for 1~1.5 hr. Stir it in softening machine at 300 to 400 RPM for 2-3 minutes.. Or stir by using spatula for approximately 3-4 minutes. b. Do not keep the speed of softening machine too high c. Add sufficient quantity of solder paste on stencil. d. Keep the container of solder paste air-tight to avoid moisture interruption. Otherwise, moisture interruption may result in solder balls/flakes. Standard printing condition is as follows: Screen -- >Flat and smooth metal stencil Squeeze--> Urethane flat type (hardness: 80 , Angle 60º) Speed of printing --> 20 ~ 40 mm / sec. Printing pressure --> 1 ~ 2 kg /om2 (Depends on printing machine ) Ambience --> 22 ~ 26 ºC , RH 50 - 70 *******Do not expose the solder paste for longer time otherwise it may get dried which will result in components dropping .******* The rate of rising temperature: 1~3ºC/sec. Preheat time: 90 – 120 seconds Preheat temperature : 160 º C – 175

Yes! I am interested


Corporate Brochure

Explore More Products


Send SMS
Ashok Gupta  (Proprietor)
Global Statclean Systems
KH 375, H Block, Gali No. 5
GT Karnal Road, Swaroop Nagar, New Delhi - 110042 , Delhi , India
Send E-mail
Share Us: